The gearbox is responsible for providing control and power to the loader, so the maintenance of the gearbox is very important. Let us take a look at the methods that are more conducive to the maintenance of the loader gearbox!
The first is daily maintenance. Check the oil and low shell oil levels, work for 50 hours (or per week), and check whether the transmission control handle is flexible and effective. The new loader works for 250 hours to clean the transmission oil pan and transmission oil filter element. Clean the oil pan filter and replace the transmission fluid after 500 working hours. After 2,000 working hours, the gearbox and torque converter were fully inspected and repaired.
Changing the oil at the correct intervals is key to maximizing the working life of the components within the transmission. Only by ensuring reasonable oil change intervals can the lubricating and protective properties of lubricating oil be exerted. Generally speaking, the maintenance intervals recommended by the complete machine manufacturer should be used as the basis, but the working environment and work intensity should also be considered. During daily inspections, if it is found that the oil has deteriorated or is mixed with impurities, it should also be cleaned and inspected, and new oil should be replaced.
The reference steps for changing the transmission oil are as follows:
1. If the loader has just finished working, pay attention to the oil temperature to cool down before proceeding to prevent burns.
2. Place a container to hold the oil under the drain plug, then slowly remove the drain plug and drain the oil. To prevent oil splashing.
3. Remove the bolts, then remove the cover and take out the rough filter screwed in the cover, remove the dirt attached to the rough filter, and then clean it in clean diesel or flush it with oil. If the rough filter is damaged, Make a replacement.
4. Inject the specified amount of oil through the oil filling port. After filling the oil, first check the oil level, and secondly check whether the gearbox and filter are leaking.
5. Then press back in sequence. It is best to start the loader and check whether it is correct.
